What are the fault types of screw stacker?

Common faults of screw stacker include non operation, unsatisfactory mud discharge effect, aging accessories, etc. different solutions shall be taken according to different fault types. The following describes "fault types and tests of screw stacker".

1、 Fault types of screw stacker

1. The screw stacker does not operate. When the screw stacker is not running, the electrical circuit shall be checked generally, only when the electrical appliance and circuit are OK during the initial operation and commissioning. It may be short circuit or aging. If the circuit problem is eliminated, we will check whether there is a problem with the reducer. This check is mainly to see whether there is heating or abnormal noise.

2. After the power supply of the screw stacker is started, it can work, but its mud discharging effect is not ideal and its working efficiency is relatively low. Generally, this phenomenon should not occur in the new screw stacker. If the machine has been used for three or four years, it should occur more or less. In fact, in case of such a situation, just contact the manufacturer of the screw stacker, The spindle of the screw stacker can be handed over to the original screw stacker manufacturer for repair.

3. Machine parts are aging. Find the aging parts directly and replace them. For other problems or faults of the screw stacker, please refer to the product manual accompanying the machine. There are solutions to various faults.

2、 Tests to be done before the screw stacker works

1. First of all, the screw stacker is a small combined machine with relevant equipment and control cabinet set on the same base, so the device is very simple, and it operates at low speed, so the output power is relatively low and the consumption of electric energy is very small. Even when the large model operates, the power consumption per hour does not exceed 2 degrees.

2. Moreover, the screw stacker can be widely used in various fields, and can be widely used in sludge dewatering in municipal sewage, food, beverage, slaughtering and breeding, printing and dyeing, petrochemical, papermaking, leather, pharmaceutical and other industries; The equipment is suitable for various types of sludge with high and low viscosity, especially oily sludge, which can be described as a sharp tool for oily sludge dewatering! Because mechanical kneading and dehydration are directly selected, there is no need for large bodies such as rollers, so the machine is planned to be appropriate and light; The body is made of stainless steel. As long as the spiral shaft and swimming ring are used to replace the parts, it has long service life and durability.

3. In addition, the rotating speed of the spiral shaft is about 2 to 3 rpm, there is no oscillation and the noise is very small; The lamination has self-cleaning function, will not have blocking problem, only needs a few water scouring, and has no secondary water pollution; In addition, the sludge operates under such a slow operation state and the odor is not dispersed, so a very good operation environment is invented, which is the reason why it can successfully enter China's scientific and technological products.

The above is the introduction of "fault types and testing of screw stacker". Please feel free to contact us if you have any questions.